CARTEK PM-04
Entry-level Power Distribution Module featuring 4 x 12A outputs
This Power Distribution Module is ideal for race cars and motorcycles which have minimal onboard electrical circuits but still require rugged and reliable protection and control. Simple connections and no configuration procedures makes this system very easy use and quick to install. The 4 x 12 amp outputs can be used to control power to various devices such as ECUs, instrumentation, lighting, starter solenoid, radiator fan, etc. Channels will automatically shut down if a short circuit or over-current is detected – LED Status indication on the PDM makes fault finding simple.
KEY FEATURES
- 4 x 12 Amp protected outputs – connection through 4 spade terminals
- 4 x Ground switched inputs – connection through 4 pin Binder connector
- Plug’n’Play – no configuration required.
- LED status indication.
- Small, lightweight design – only weighs 80 grams
DIMENSIONS
DOWNLOADS
PDM COMPARISON
 |  |  |
|
| CARTEK PM-04 | CARTEK PDM-5 | CARTEK PDM-4C | |
| Outputs | 4 | 5 | 4 |
| Output Current Limits | 12A (fixed) | 5A/10A/15A/20A (selectable with Soft-start) | 5A/10A/15A/20A (selectable with Soft-start) |
| Inputs | 4 | 5 | 4 |
| Master shut down input | No | Yes (auxiliary input) | Yes (auxiliary input) |
| Input types | Active low | Active low/Active High/Edge Triggered/PWM control | Active low/Active High/Edge Triggered/PWM control |
| Functions | No functions - controlled directly by input | Yes - choice of functions for outputs | Yes - choice of functions for outputs |
| Additional Lighting control functions | No | Yes | No |
| CAN-BUS | No | No | Yes |
WHERE TO BUY
Contact
CARTEK AUTOMOTIVE ELECTRONICS LTD
Unit 25, Mitchell Point
Ensign Way, Hamble
Southampton, SO31 4RF
United Kingdom
Tel: +44(0)2380 457747
Email: info@cartekmotorsport.com
Cartek Links
